This shows the symbolic names of each feature. To find the feature name, click Model Intent > Switch Symbols (Fig.In the example below, we’ll vary the drive size, that is, the extruded fitting that attaches to the wrench handle. Identify a feature you want to modify for your variants.Create or open a part to reference (your “generic socket”).To create a Family Table, follow these steps: You can apply this concept to bolts, washers, or even larger assemblies, saving yourself loads of time and disk space. Many of the features in Pro/ENGINEER require you to sketch a profile then perform some sort of operation on. With table-driven design, every row in your table produces a different variant of the generic. Rather than model and save each piece separately, you can create a generic socket in PTC Creo, and then use a Family Table to quickly create variants of the generic by changing just the relevant dimensions or parameters. ![]() For example, think of a collection of socket wrenches ranging from 0.25 to 1 inch. governmental approval is required for you to obtain or use (or continue to use) PTC software.Suppose you want to design a group of similar products that vary only slightly from each other. ![]() You hereby acknowledge and further agree that (i) a violation of any of the above representations constitutes a violation of your license to use PTC software and therefore will be cause for the immediate termination of your license to use any PTC software and (ii) PTC may terminate your license to use PTC software in its entirety, effective immediately and without advance notice, if PTC or an agency of the U.S.
0 Comments
Leave a Reply. |